Dotmod Dotstick Tank Clearomizer

The DotStick Tank is a clearomizer equipped with a PCTG tank of 2ml.

Compatible with the DotStick coils, it is meant for a tight draw in indirect inhaling (MTL) as much as for a slightly more airy vape in restrictive direct inhaling (RDL).

A compact format

The DotStick tank is particularly suited to electronic mods with a reduced format, thanks to its 22mm diameter.

Its 2ml tank is topped with a standard 510 drip tip.

Its bottom part includes an airflow ring enabling the setting of the airflow.

Dotmod's DotStick Tank clearomizer

The DotStick coils

The DotStick Tank clearomizer is delivered with two DotStick coils:

• 1 0.7ohm DotStick coil (pre-installed): for a rather tight vape, to use between 14 and 20 watts
• 1 0.4ohm DotStick coil: for a more airy draw, to use between 20 and 30 watts

After two to three weeks of use, the coil will start to show some signs of wear, such as a loss of flavors or a light burnt taste.

It will be time to replace it with a new one.

For this:

1. Push on the bottom part of the clearomizer before pivoting a quarter turn to take it off
2. Pull on the used coil to take it off
3. Soak a new coil with some drops of e-liquid
4. Insert it in the same compartment as the old one
5. Close the bottom part of the clearomizer
6. Fill the tank with e-liquid
7. Wait for some minutes before vaping it so the coil is correctly primed

Adjustable air intakes

Dotmod allows you to precisely adjust your draw type by equipping the clearomizer with an airflow adjustment system.

Alternate between a tight draw and a cloudier vape by simply turning the ring located on the lower part of your DotStick Tank.

The airflow of Dotmod's DotStick Tank clearomizer

A refillable 2ml tank

To fill the DotStick Tank clearomizer with e-liquid, follow the steps below:

1. Disconnect the clearomizer from the mod
2. Take the bottom part of the DotStick Tank: push then unscrew
3. Insert the bottle tip into the small hole
4. Pour your e-liquid
5. Reconnect the clearomizer on your mod

Reminder: wait for some minutes if you use a new coil.

The filling of Dotmod's DotStick Tank clearomizer

Box contents

• 1 2ml DotStick Tank clearomizer
• 1 0.7ohm DotStick coil (pre-installed)
• 1 0.4ohm DotStick coil
• 1 user guide

The DotStick Tank clearomizer is made by Dotmod.

Box contents of Dotmod's DotStick Tank clearomizer