Vaponaute VT26 Clearomizer

Vaponaute offers a clearomizer specifically designed for direct vaping, delivering an airy draw.

Featuring a 4ml straight Pyrex tank, the VT26 is designed to accommodate Innokin’s PZP Max coils.

With top-fill and top airflow, it’s specially designed to provide you with a high-quality vaping experience.

The VT26 clearomizer with Aspire's Huracan EX mod

The design of VT26

Made in stainless steel, the VT26 presents a straight format for a height of 57.3mm and a 26mm diameter.

Its original 510 drip tip can be replaced with the wider-diameter one included in the box.

Its standard 510 pin allows it to be connected to most mods on the market.

Vaponaute's VT26 clearomizer

The PZP Max coils

The VT26 comes with two PZP Max coils from Innokin.

Designed for an airy draw in direct inhaling (DL), they’re also engineered to deliver optimal flavor.

Depending on your needs, choose the one that suits you best from the following:

• 1 0.4ohm PZP Max coil (pre-installed): for an airy vape, use between 40 and 60 watts
• 1 0.2ohm PZP Max coil: for an even airier draw, use between 60 and 80 watts

After two to three weeks of use, your coil will show some signs of wear, such as a loss of flavor or a slight burnt taste.

It will then be time to replace it with a new one.

To do this:

1. Unscrew the bottom section of the VT26
2. Pull the used coil out of its compartment
3. Soak a new coil with a few drops of e-liquid
4. Then insert it into the clearomizer in place of the old one
5. Screw the bottom section of the VT26 back on
6. Fill the tank with e-liquid
7. Wait a few minutes before vaping to allow the new coil to prime properly

An efficient top airflow

The VT26 features an airflow ring located at the top of the clearomizer.

Rotate the ring to open or close the air intake holes to customize your vaping experience.

The more you open the air intakes, the airier your draw will be.

The airflow of Vaponaute's VT26 clearomizer

4ml top-fill

Featuring a straight Pyrex tank with a 4ml capacity, the VT26 features a top-fill system.

So, when it’s time to refill your clearomizer with e-liquid, simply:

1. Push down on the top cap of the VT26 at the mark
2. Insert the narrow tip of your bottle into the fill port, which is covered by a silicone membrane
3. Gently pour the e-liquid until the tank is three-quarters full
4. Close the top cap by pushing it back into place

Is your coil new? Be sure to wait 5 to 10 minutes before vaping so that it can properly soak up the e-liquid.

Filling Vaponaute's VT26 clearomizer

Box contents

• 1 4ml VT26 clearomizer
• 1 0.4ohm PZP Max coil (pre-build)
• 1 0.2ohm PZP Max coi
• 1 spare straight Pyrex
• 1 spare 510 drip tip
• 1 set of spare pieces
• 1 user guide

The VT26 clearomizer is made by Vaponaute.

Box contents of Vaponaute's VT26 clearomizer