Lost Vape Centaurus UB AIO Cartridge

Identical to the original included with your Centaurus B80 kit, this clearomizer is made to hold the UB Ultra coils of Lost Vape (not included), in 0.15Ω or 0.2Ω.

With a capacity of 5ml, the Centaurus UB AIO cartridge will perfectly go at the same place as the old one, or in replacement of the Boro RBA tank.

The Centaurus UB AIO cartridge on Lost Vape's Centaurus B80 kit

The cartridge that simplifies the vape

Are you the happy owner of a Centaurus B80 kit and you wish to change your UB AIO cartridge? Or do you love to alternate between fruity and tasty flavors all day long?

So don't wait any longer, and get this spare tank, identical to the original included with your kit. Contrary to the Boro RBA tank, also included in the kit, the Centaurus UB AIO cartridge is ideal for beginners in rebuildable. Its particularity: it is compatible with all the pre-made UB Ultra coils of Lost Vape (0.15Ω and 0.2Ω).

Lost Vape's Centaurus UB AIO cartridge

Compatible with the UB Ultra coils

According to the type of draw desired, more or less airy, you can associate the Centaurus UB AIO cartridge with:

• 0.15Ω UB Ultra V3 coil: to use between 60 and 80 watts, for a very airy draw
• 0.2Ω UB Ultra V3 coil: to use between 40 and 60 watts, for a more restrictive draw

Once your coil is used, after two to three weeks of use, you just need to change it with a new one so you can enjoy the best of your Centaurus B80 kit!

Warning, the Centaurus UB AIO cartridge is only compatible with the UB Ultra coils between 0.15Ω and 0.2Ω (non-compatible with the Ultra Boost V2 0.3Ω).

Easily change your coil

Do you start to feel a loss of flavors or a light burnt taste? It is time to change your UB Ultra coil.

Follow the steps below to easily replace it:

1. Take the magnetic panel out of your Centaurus B80 kit
2. Remove the drip-tip and unscrew the nut with a wrench included in the kit
3. Take the Centaurus UB AIO cartridge out
4. Remove the airflow wheel
5. Soak a new coil of some drops of e-liquid before inserting it
6. Fill the tank with e-liquid
7. Put the UB AIO cartridge back
8. Reattach the magnetic panel on the kit

N.B: Don't forget to wait 5 to 10 minutes before vaping, so the new coil is correctly primed.

A side filling

When you need to recharge the 5ml tank of the Centaurus UB AIO cartridge, you'll proceed as follows:

1. Take the magnetic panel out of the Centaurus B80 kit
2. Lift the silicon strip on the main side of the tank
3. Insert the bottle cap in the filling hole
4. Pour your e-liquid
5. Put the silicon strip back
6. Reattach the magnetic panel

The filling of Lost Vape's Centaurus UB AIO cartridge

The Centaurus UB AIO cartridge for the Centaurus B80 kit is made by Lost Vape. It is sold individually and without coils. It is compatible with the UB Ultra coils of Lost Vape, 0.15Ω or 0.2Ω.