Lost Vape Centaurus E40 Max Podmod

Lost Vape offers equipment at the cutting edge of technology meant for vape beginners and experts.

With a 1,400mAh built-in battery, the Centaurus E40 Max delivers up to 40 watts of power.

This podmod is made to hold the E-Plus cartridges with sealed coils and allows vaping in indirect inhaling (tight draw in MTL), like in an airy vape in direct inhaling (DL).

Lost Vape's Centaurus E40 Max podmod

A rectangular format and a lightweight

Intending to offer sturdy and light equipment, Lost Vape made a podmod in aluminum alloy in a compact format with dimensions of 95x43.3x20mm.

Your kit is made of two panels printed with the centaur of the brand, and a main side offering from top to bottom:

• Ignition button
• 0.42" OLED screen
• Setting buttons
• USB-C port

The main side of Lost Vape's Centaurus E40 Max podmod

Its rectangular design and its weight of only 87g gives it a comfortable handling and will allow you to easily slide it in all your pockets and bags.

Lost Vape also slides a lanyard in the box so you can always have your Centaurus E40 Max within easy reach!

Handling of Lost Vape's Centaurus E40 Max podmod

An evolutive podmod: from beginners to experts

Your Centaurus E40 Max is only made of an electronic mod with a 1,400mAh built-in battery and a 3ml E-Plus cartridge with a sealed coil.

Once the latter is used, you only have to replace the whole cartridge with a new one without having a lot of handling to do!

The connection between the mod and your tank is made through a magnetic system allowing you to clip and unclip the cartridge out of the compartment. This tip will ease the process especially if you wish to alternate flavors during the day!

All these advantages make the Centaurus E40 Max a podmod for beginners and experts looking for simple and performing equipment.

The magnetic connection of Lost Vape's Centaurus E40 Max podmod

A unique power setting

Lost Vape lets you hand in the power settings from 5 to 40W.

For this, use the setting buttons to increase or lower. According to the value of the sealed coil used, your Centaurus E40 Max will be restricted when you reach the maximum power.

Access to all necessary information about your vape with the 0.42" OLED screen of your podmod, like the capacity level of the battery or the puff counter.

The OLED screen of Lost Vape's Centaurus E40 Max podmod

1,400mAh of capacity rechargeable by USB-C

Not only your Centaurus E40 Max is easily transportable thanks to its compact and light format but it will also save long hours thanks to a capacity of 1,400mAh.

Keep track of the built-in battery's remaining capacity in real-time, thanks to the OLED display, and easily recharge as needed by plugging the included USB-C cable into the dedicated port.

This port is located on the main front panel, just below the adjustment switches.

The USB-C port of Lost Vape's Centaurus E40 Max podmod

The E-Plus cartridge

Perfectly held in place on its magnetized connector, the E-Plus cartridge has an e-liquid capacity of 3ml.

Its reservoir is easily refilled from the front, simply by lifting the silicone tab after removing the cartridge from the podmod.

The latter is equipped with a sealed coil, offered in a range of values.

Two types of E-Plus cartridge are included with your Centaurus E40:

• 1 E-Plus cartridge with a 0.3ohm sealed coil (pre-installed): for a rather airy draw in direct inhaling (DL), to use between 30 and 40W
• 1 E-Plus cartridge with a 0.6ohm sealed coil: for a tight vape in indirect inhaling (MTL), to use between 16 and 21W

The E-Plus cartridge of Lost Vape's Centaurus E40 Max podmod

An adjustable airflow

Lost Vape's Centaurus E40 Max features an airflow switch, allowing you to adjust the airflow between a restrictive draw and an airier vape.

Simply slide the knob to release more or less air intake, depending on your vape preferences!

You'll find the switch on the opposite side of the front panel.

The airflow button of Lost Vape's Centaurus E40 Max podmod

Easily fill your tank

To recharge the 3ml of E-Plus cartridge's tank, follow the steps below:

1. Take the cartridge off the magnetic base
2. Lift the silicon strip
3. Insert the thin tip of your bottle
4. Pour your e-liquid
5. Carefully close the strip
6. Replace the cartridge on the podmod
7. If you use a new cartridge, wait for some minutes before vaping if you let the new coil be primed with e-liquid

Filling of E-Plus cartridge of Lost Vape's Centaurus E40 Max podmod

Box contents

• 1 1,400mAh Centaurus E40 Max podmod
• 1 0.3ohm E-Plus cartridge (pre-installed)
• 1 0.6ohm E-Plus cartridge
• 1 USB-C cable
• 1 lanyard
• 1 user guide

The Centaurus E40 Max podmod is made by Lost Vape.

Box contents of Lost Vape's Centaurus E40 Max podmod