Voopoo Argus Pod Empty Cartridge (x2)

Use your Argus P1 and Argus Z podmods and its reusable cartridges, compatible with the ITO coils, and switch e-liquid flavors as you wish!

Voopoo offers you a pack of 2 spare empty cartridges.

Voopoo’s Argus P1 cartridge

Empty 2ml cartridges for the Argus P1 or Z podmod

This pack of empty cartridges is intended for any vaper who owns one of Voopoo’s Argus P1 or Z podmods and wishes to use reusable tanks. The latter are compatible with all of the ITO coils.

These cartridges are identical to the ones in the original Argus P1 kit. They have the same size, same tank capacity, and are made from the same PCTG material. They can be refilled through the side of the tank.

Connecting the reusable Argus P1 cartridge on Voopoo’s Argus P1 podmod

The ITO coils

Seeing as these cartridges are reusable, they do not contain a pre-installed coil inside their tanks. You will have to insert one and change it every 2 to 3 weeks on average, as soon as it is worn out.

The Argus P1 cartridges will accept any of Voopoo’s ITO coils.

To install and change an ITO coil, proceed as follows:

1. Remove the cartridge from the pod's magnetic connector
2. Turn it over
3. Grab a new ITO coil
4. Soak it in e-liquid, by pouring a few drops on its cotton wick
5. Insert it in the dedicated slot in the middle of the tank
6. Put the cartridge back on the pod mod's magnetic connector
7. Then, just fill your cartridge’s tank, wait a few minutes, and enjoy!

A tight vape, but with an adjustable draw!

These cartridges are specifically designed for the Argus P1 or Z podmod. They produce a fairly low amount of vapor with a relatively tight throat hit and a more than accurate flavor rendition.

To switch from an indirect inhale (MTL) to a restrictive direct inhale (RDL), use the sliding switch on the podmod’s front panel. The latter opens the air intake more or less, depending on your preference.

The airflow switch of Voopoo’s Argus P1 podmod

Sturdy 2ml tanks that are filled from the side

Once the ITO coil is installed inside your Argus P1 cartridge, you will have to fill it with your favorite e-liquid!

As they are made from PCTG, the Argus P1 cartridges are solid and compatible with any type of e-liquid. They can hold up to 2ml of liquid, and must be filled from the side:

1. If the cartridge is connected to the Argus P1 pod mod, remove it first
2. Lift the tab on the side of the cartridge
3. Tilt the cartridge to make the filling easier
4. Insert the tip of your bottle of e-liquid into the hole and fill up
5. Close the tab, put the cartridge back on the pod mod's magnetized connector, and wait for 5 to 10 minutes before vaping

Filling Voopoo’s Argus P1 cartridge

The Argus P1 cartridges for the Argus P1 or Z podmods are manufactured by Voopoo. They are only available in packs of two, without any coils or accessories.