Voopoo ITO Coils (x5) Drag Q
Set of 5 ITO coils for Drag Q pod, ITO-X cartridge...
The Drag Q pod as well as its ITO-X cartridge will work thanks to ITO coils from Voopoo. Find them here in a pack of 5, ohm value to choose from, for a customisable vape !
ITO Coils, experts in MTL and RDL vape !
To accompany the Drag Q pod, this true MTL vape expert, Voopoo has designed custom-made coils, the ITO Coils. Their internal construction has been optimised to guarantee exquisite flavour (thanks to the Mesh) and increased durability.
You can choose between :
- ITO-M0 0.5Ω coils. Use from 18 to 25 watts, restrictive direct inhale vape (RDL)
- ITO-M2 1.0Ω coils. Use from 10 to 14 watts, indirect inhale vape type (MTL)
- ITO-M3 1.2Ω coils. Use from 8 to 12 watts, very tight indirect inhale vape (Tight MTL)
Note that with the 1 and 1.2 ohm coil, you can use any type of e-liquid, with high nicotine content, nicotine salt or CBD. However, prefer high PG ratios, i.e. e-liquids composed of 50% or more of propylene glycol.
How correctly use your ITO Coil ?
As with any component of your electronic cigarette, a properly adjusted and used resistor will last you longer. So remember to prime it before installing it in your tank, to be patient after filling your tank to be sure it is well soaked, or not to exceed the power range recommended by the manufacturer.
A coil is usually changed every 2 to 3 weeks. On the ITO-X cartridge of your Drag Q pod, you will proceed as follows:
- Remove the cartridge from the podmod's magnetic base
- Turn it over
- Remove the old coil
- Unpack a new coil
- Soak its cotton with a few drops of e-liquid
- Place it in the centre of the tank, in the dedicated space
- Proceed to the filling if necessary
The ITO Coils for Drag Q pod and ITO-X cartridge are made by Voopoo. They are only sold in set of 5.