BP Mods Light Saber Cartridge

You’ll probably need a spare tank if you’re vaping with the Light Saber S, L, or X kits.

Whether it's to replace the already installed tank or switch between two different flavors, you'll need this 5ml cartridge. It’s identical to the original one.

BP Mods’ 5ml Light Saber cartridge

A 5ml PCTG cartridge compatible with the Light Saber

The Light Saber cartridge from BP Mods has been designed specifically for the Light Saber Model X/S (the 1500mAh / 40W smaller model) and the Light Saber Model L (the longer 2200mAh / 60W model).

This cartridge is as easy to install as it is to use, and it’s very sturdy as well, as it’s made from stainless steel and PCTG. The cartridge’s tank holds 5ml of e-liquid. Most importantly, it can accommodate several different coils and is filled from the side.

The magnetic connector used to install BP Mods’ Light Saber 5ml cartridge

Several ranges of compatible coils

If there’s one word that best describes this cartridge, it’s 'versatility'!

The Light Saber cartridge comes without any coils, but it’s compatible with many different models! In addition to the manufacturer's TMD coils, this tank can work with Voopoo’s famous PnP coils or Vaporesso’s GTX coils.

Please note that for the GTX coils, you can only use those with a value of 0.6ohm or less with this cartridge.

To install or change the coil:

1. Remove the cartridge from the magnetic connector of the Light Saber kit
2. Turn it over
3. Prime the coil with a few drops of e-liquid
4. Insert it into the middle of the tank, in the dedicated slot
5. Put the cartridge back onto the magnetic connector of the Light Saber kit

The coil should be changed every two to three weeks on average, depending on your use.

A big 5ml tank that’s filled from the side

The Light Saber 5ml cartridge can hold a nice supply of e-liquid. You won’t have to refill as often, and the process is both quick and easy:

1. Unscrew the top cap surrounding the cartridge’s drip tip
2. Lift the rubber tab covering the filling hole
3. Insert the tip of your bottle of e-liquid into said hole, whilst tilting the cartridge slightly
4. Fill, but never to the brim
5. Close the hole up, put the top cap back on, and put the cartridge back onto the kit
6. Wait 5 to 10 minutes for the coil to soak up the liquid.

Filling BP Mods’ Light Saber cartridge

The Light Saber 5ml cartridge for BP Mods’ Light Saber X, Model S, and Model L kits is manufactured by Dovpo. It does not include any coils, accessories, or drip tips.