Nevoks APX S1 Cartridges (x3)

Do you want to replace the cartridge of your APX S1 podmod, or simply have a spare tank with a different flavor?

Well, this pack of 3 disposable cartridges is made for you.

They have a 2ml tank and come with a sealed coil of either 0.8Ω or 1.2Ω.

Nevoks’s APX S1 cartridge

Three disposable cartridges for the APX S1 podmod

These cartridges are specifically designed for the APX S1 podmod and are easily clipped onto the device using the magnetic connector.

The coils are pre-installed in the cartridges, so you just have to fill them with e-liquid before use.

The kit comes with one of two sets of MTL (indirect inhale) coils :

• Either three APX S1 2ml cartridges with a sealed 0.8 ohm coil, for a tight MTL vape
• Or Three APX S1 2ml cartridges with a sealed 1.2 ohm coil, for a very tight MTL vape. These coils are particularly suited to e-liquids with nicotine salts or CBD.

Connecting the cartridge to the magnetic connector of the APX S1 podmod

A pre-installed coil

The APX S1 cartridge is equipped with a sealed coil, characteristic of so-called 'disposable' cartridges.

Thus, the coil is pre-installed in the tank and cannot be changed. Once the cartridge is worn out (after about two or three weeks depending on your vaping habits), simply throw it away and replace it.

An adjustable draw

Do you want to adjust your draw? No problem! Nevoks has it all figured out.

Simply rotate the APX S1 cartridge by half a turn to switch from a tight draw (restrictive MTL) to a slightly airier draw (loose MTL), and vice versa!

A side-fill tank

The APX S1 cartridge can hold up to 2ml of e-liquid and is equipped with a waterproof anti-condensation system.

Our advice for this cartridge would be to use e-liquids with a high propylene glycol content (at least 50% of PG).

The APX S1 cartridges are filled from the side:

1. Lift the silicone tab on the side of the cartridge
2. Tilt the cartridge backward slightly, then insert the tip of your bottle of e-liquid into the hole
3. Fill with e-liquid, but not to the brim
4. Close the silicone tab
5. Put the cartridge back onto its magnetic connector
6. Wait 5 to 10 minutes until the coil is soaked in e-liquid
7. Inhale and enjoy!

Filling the APX S1 cartridge

The APX S1 cartridges are manufactured by Nevoks. They are only available in packs of 3, with the coil value of your choice.