Nevoks Feelin C1 Cartridge (x2)

The Feelin C1 cartridge pack for your Nevoks podmod will allow you to do several things, replace a damaged tank, alternate between several flavors without wasting time, but also personalize your equipment by adding colors!

You will enjoy a pack of two empty PCTG tanks, with a capacity of 2.8ml.

Two cartridges, choice of colors!

The two cartridges presented in this pack are exclusively dedicated to the Feelin C1 podmod from Nevoks. They are exactly the same as the original, with a 2.8ml PCTG tank, a side filling system, a TPE drip tip, and full SPL compatibility.

But here, you will have another opportunity to choose another color to customize your device!

Install the Feelin C1 cartridge on the Feelin C1 podmod by Nevoks

SPL coils compatible

Here you will receive two empty Feelin C1 cartridges, either not equipped or with coils. However, you will have to install coils if you want to use them on your Feelin C1 pod! Check out the SPL coils by Nevoks, the only compatible coils.

From the SPL 0.6 ohm to the SPL 1 ohm, you will get a tight vape, in indirect inhale (MTL), or more airy, in restrictive direct inhale (RDL). If you want to enjoy a high-nicotine e-liquid, in nicotine salt or CBD, the 1 ohm will be very suitable!

You will change your SPL Coil approximately every two to three weeks. To do this, remove the cartridge from the pod and turn it over. From there, you can remove the old coil and replace it with a new one, primed beforehand!

Rotating the cartridge to adjust its draft

Your Feelin C1 pod by Nevoks is, of course, equipped with an ingenious air supply system. However, it has no knob or system to adjust it.

It's the cartridge that you can influence your draw. Simply change the direction of the cartridge, on the one hand, it allows pure MTL sensations, on the other hand, it invites you to an RDL session!

The airflows of the Feelin C1 podmod by Nevoks, adjustable by its cartridge

The lateral filling of your 2.8ml cartridge

With its generous 2.8ml PCTG tank, the Feelin C1 cartridge allows amazing autonomy in e-liquid. The refill will not be very frequent, and when it's time to do it, it will be infinitely simple to achieve!

1. Remove the cartridge from the pod's magnetic base
2. Open the tab at the bottom of the cartridge
3. Tilt the cartridge to avoid any leakage of e-liquid
4. Insert the tip of your bottle and refill
5. Wait about ten minutes to be sure of the proper priming of your coil

The filling of the Feelin C1 cartridge by Nevoks

The set of Feelin C1 cartridges for the Feelin C1 podmod is made by Nevoks. These cartridges are only suggested in a set of 2. They are delivered empty, without a coil.