Nevoks Feelin Mini Cartridge (x2)
Pack of 2 empty tanks of 2ml capacity, for Feelin Mini pod
-
Volume2ml
-
Compatible coilsSPL
-
TankPCTG
-
Brand
Replace the cartridge of your Feelin Mini pod by Nevoks and ensure double security! The manufacturer presents its set of two spare tanks, perfectly identical to the original.
With these 2 empty cartridges of 2ml, you can alternate between several flavors and diversify the pleasures!
Two spare cartridges, Feelin Mini pod
Nevoks prevents any drop, loss, or breakage, but also offers you the possibility to alternate pleasures on your Feelin Mini pod. Only compatible with this kit, discover a set of two empty cartridges, spare.
These TPU (thermoplastic) and PCTG tanks guarantee excellent solidity, as well as a nice capacity of 2ml and easy filling. To use them on your pod, simply add the manufacturer's SPL coils, fill them, and clip them onto the podmod's magnetic base.
The Feelin Mini cartridges by Nevoks
Compatible SPL coils
All your pods and Feelin cartridges are compatible with SPL coils from the manufacturer. The Feelin Mini cartridges should not be an exception!
However, the Feelin Mini pod cartridges are made for certain SPL coils only, the 0.8 and 1 ohms. They will not be compatible with 0.3 or 0.6 ohms.
With the SPL coils, you ensure a tight vape, typical indirect inhale (MTL). You can use any type of e-liquid (high nicotine, nicotine salt, or CBD). However, prefer e-liquids with a fairly high PG ratio, or composed of 50% or more of propylene glycol.
N.B: You should change your SPL coil every 2 to 3 weeks or so, by unclipping the cartridge from the pod's magnetic base, then turning it over and removing the used coil. You will then install a new one, previously soaked with a few drops of e-liquid on its cotton pads.
Turn the cartridge to adjust the draught!
On the Feelin Mini pod, the air inlet is fixed, which means that it's not directly accompanied by an airflow adjustment mechanism. There are two ways of adjusting your draw:
- Position the cartridge with the silicone tab facing the air inlet: you will obtain a very tight MTL draw
- Position the cartridge with the silicone tab opposite the air inlet: you will obtain a Tighten MTL
Simply lift the silicone tab to fill!
Concerning the filling of these Feelin Mini cartridges by Nevoks, you will have to look at their side. You will find an efficient silicone tab, protecting the access to the hole dedicated to the e-liquid refill.
Lift this tab, insert the tip of your bottle into the opening, and tilt the cartridge slightly backward to avoid any spillage or leakage of e-liquid during refilling.
N.B.: Never fill your cartridge to the brim. Also, always wait about ten minutes after the maneuver, to be sure that your resistance is properly primed.
The filling of the Feelin Mini cartridges by Nevoks
The Feelin Mini cartridges for the Feelin Mini 750mAh pod are made by Nevoks. They are sold in a set of 2, empty of any coil.
Volume | 2ml |
---|---|
Compatible coils | SPL |
Tank | PCTG |
Fill type | From the side |
Drip-tip | Proprietary |
Connector pin | Proprietary |
Your comment cannot be sent
feedback Report a comment
Abuse report sent
Your report cannot be sent