Hellvape Dead Rabbit R Coil Kit

A complete kit for making your Dead Rabbit R Tank coil builds!

Your Dead Rabbit R Tank atomizer uses a system of mesh strips and cotton laces to heat up your e-liquid.

Therefore, Hellvape offers you a set of 10 Mesh strips, of 0.2ohm each, along with 10 laces of organic cotton, to replace your old coils when they're worn out!

The 10 mesh strips are made from Kanthal A1 and each has a resistance value of 0.2ohm. They should be used between 50 and 60 watts if you want to get the best flavours out of them.

The 0.2ohm Mesh strips of the Dead Rabbit R Tank Coil kit by Hellvape

These mesh strips come with ten laces of organic cotton, making your coil-building experience that much easier. The cotton wraps itself around the metallic mesh, guaranteeing flawless e-liquid capillarity. No more dry hits, thanks to this effective kit!

Hellvape's set of flat cotton laces, specifically designed for the Dead Rabbit R Tank

Assembling your Dead Rabbit R Tank atomizer coils

As you know, the Dead Rabbit R Tank atomizer works in a unique way. It may seem complicated, but don't worry, equipping your new coil is quick and easy:

1. First, rotate the Dead Rabbit's airflow ring to access its two small screws. Unscrew them slightly.
2. Take a 0.2Ω mesh strip and an organic cotton lace from the kit.
3. Centre the mesh on the cotton lace with its pegs down.
4. Use the tool provided in your atomizer kit to wrap the whole thing around its axis, making sure to align the mesh's pegs.
5. Put the whole thing inside the deck and tighten the airflow ring screws.
6. Trim the excess wire protruding from the deck with a pair of wire cutters.
7. Finally, remove the coil-building tool from the deck's centre and generously soak the cotton with e-liquid.

The pack of 10 mesh strips and 10 cotton laces for the Dead Rabbit R Tank atomizer is made by Hellvape.

The contents of Hellvape's Dead Rabbit R Coil kit