OXVA Oneo Pro Cartridge (x3)

Replace the cartridge in your Oneo Pro with this pack of three cartridges that are identical to the original one that came with your podmod.

Each cartridge has a 4ml e-liquid capacity.

Their tank is equipped with a sealed coil, available in a variety of resistances.

These cartridges are compatible with the entire Oneo podmod collection from OXVA.

OXVA's Oneo Pro cartridge

A pre-installed coil

Each of the three cartridges in this pack is equipped with a coil sealed inside the tank.

Depending on your preferred draw, select the appropriate value when ordering from the following options:

• Pack of 3 Oneo Pro Cartridges with 0.8ohm coils: use between 14 and 18 watts
• Pack of 3 Oneo Pro Cartridges with 0.6ohm coils: use between 20 and 26 watts
• Pack of 3 Oneo Pro cartridges with 0.4ohm coils: use between 28 and 34 watts

Once the coil is worn out, typically after two to three weeks of use, simply replace the entire cartridge with a new one to continue using your Oneo Pro podmod.

A 4ml tank

Just like the original, each Oneo PRO cartridge has a 4ml tank.

When it’s time to fill it with your e-liquid, follow the steps below:

1. Lift the silicone tab on the side of the tank
2. Insert the narrow tip of your bottle into the fill port
3. Gently pour in your e-liquid
4. Carefully close the tab

If your cartridge is new, wait a few minutes before vaping to allow the coil to properly soak up the e-liquid.

Filling of OXVA's Oneo Pro cartridge

The Oneo Pro cartridge is made by OXVA and is only sold in a pack of three.