Aspire Fluffi Cartridge (x2)

Does the cartridge of your Fluffi Pro podmod present signs of wear, like a flavor alteration or disagreeable aftertaste? The manufacturer Aspire offers this pack of two Fluffi cartridges.

Loyal to the model you received with your podmod, these cartridges have a capacity of 3.5ml, a lateral filling, and a magnetic connection with a reliable and safe anchor on your podmod.

Equipped with sealed coils, you don't need to replace them. When they reach the end of their life, simply throw away the used cartridge and replace it with a new one.

Aspire's Fluffi cartridge

A pack of two spare cartridges

By receiving these two Fluffi cartridges, you'll have the possibility to:

• Quickly replace the used or damaged cartridge of your Fluffi Pro podmod
• Vary your e-liquid flavors all day long by going from one cartridge to another quickly

They are mainly meant for vape beginners or experts looking for a simple vape solution, thanks to their built-in coil.

A 0.4ohm built-in coil

These two Aspire tanks bet on simplicity: the coil is sealed inside, so you won't need to change it.

Indeed, as soon as you feel a loss of flavor or a light burnt taste, you can throw the whole cartridge out and replace it with a new one.

Which coil value will you receive? Aspire offers:

• 2 cartridges equipped with a 0.4ohm Dual Mesh sealed coil: known to work between 30 and 40 watts; you'll get an airier draw in RDL
• 2 cartridges equipped with a 0.6ohm sealed coil: to use between 11 and 18 watts, for a tight vape in indirect inhalation (MTL)

How to fill your Fluffi cartridges?

Once the e-liquid level is too low, it's time to refill it.

For this, Aspire provides a lateral filling system (on the side), simple and accessible. You don't need to take the cartridge off the podmod.

Here are some steps to follow to refill your 3.5ml cartridge:

1. Take the magnetic cap off your Fluffi Pro podmod
2. Lift the silicone tab located on the cartridge's side
3. Insert the thin tip of your e-liquid bottle into the filling hole
4. Softly pour the e-liquid
5. Close the silicone tab
6. Reposition the podmod's cap

Important: if you use a new cartridge, you'll have to wait for at least ten minutes to enable the coil to soak in e-liquid before vaping it. The priming is important so as not to burn the coil's cotton.

Filling Aspire's Fluffi cartridge

The Fluffi cartridge is made by Aspire. It is sold exclusively in a pack of two.