Hellvape VSEE (x3) Cartridge

To use your VSEE equipment from the same manufacturer, Hellvape offers a pack of three cartridges with fixed coils.

Available in different coil values, namely 0.6ohm and 0.8ohm, the VSEE tanks can be adjusted to your indirect inhaling (MTL) draw, allowing you to enjoy a slightly different experience depending on your choice of coil.

You can opt for a tight MTL draw or a slightly airier indirect inhaling vape, depending on your daily needs.

Made from a silicone strip, you can fill your tank from the side without having to remove it from its magnetized base.

Hellvape's VSEE cartridge

Two tanks of your choice

Are you an enthusiast of semi-airy vape? Do you prefer a tighter draw?

Hellvape meets your needs with the following cartridges:

• A cartridge of 2ml 0.8ohm sealed coil: to use between 14W and 18W, for a tight draw in MTL
• A cartridge of 2ml 0.6ohm sealed coil: to use between 15W and 21W, for an MTL vape but slightly more airy

The cartridge filling

To charge your e-liquid, the brand has opted for a side filling system for this 2ml tank.

We recommend that you follow the steps below to fill your cartridge:

1. Locate the silicone strip on the side of your tank and lift it up
2. Insert the dropper into the hole
3. Fill with e-liquid until it is three-quarters full
4. Close the strip

The lateral filling of Hellvape's VSEE cartridge

The cartridge of VSEE One podmod is made by Hellvape and is only sold in a pack of three. It has a 0.6ohm or 0.8ohm sealed coil, to select during the order.