Dotmod DotPod Nano Cartridges (x2)

Continue to enjoy vaping with Dotmod's DotPod Nano! Once your cartridges are worn out, replace them with these 2ml tanks, each containing a 0.8ohm or 1ohm coil, offered as a pack of two!

The 1ohm 2ml disposable cartridge used by Dotmod’s DotPod Nano

A pack of two disposable cartridges, with 0.8 or 1 ohm coils

The DotPod Nano uses disposable cartridges. Inside these tanks, you will find a ready-made coil, which cannot be removed or replaced.

Three types of cartridges are available:

• The DotPod Nano 2ml cartridge with a 1Ω coil. The podmod will automatically set the power to 14 watts. Note this type of cartridge is especially suitable for e-liquid with high dosages of nicotine, nicotine salts or CBD.
• The DotPod Nano 2ml cartridge with a 0.8Ω coil. The podmod will automatically set the power to 16 watts.
• The DotPod Nano 2ml cartridge with a 0.6Ω coil. The podmod will automatically set the power to 18 watts.

Every 2 to 3 weeks or so, when the coil is worn out (unpleasant taste, less vapour than usual), throw away the entire cartridge and put another one in its place.

Installing the cartridge on Dotmod’s DotPod Nano using the magnetized connector

Filling the DotPod Nano 2ml tank

The cartridge can hold 2ml of e-liquid. It's made from PCTG, which is a robust material.

To fill the tank, simply do the following:

1. Pull the cartridge out
2. Lift the red tab on the side of the cartridge
3. Slightly tilt the cartridge backward to avoid any e-liquid overflow
4. Insert the tip of your bottle of e-liquid into the hole and fill (but never to the brim)
5. Close the tab and put the cartridge back in its place
6. Wait 5 to 10 minutes before vaping

Filling the tank of Dotmod’s DotPod Nano cartridge

The DotPod Nano 2ml cartridges for the DotPod Nano are manufactured by Dotmod. They are only sold in sets of two, with a choice of 3 different values (2 x 0.6ohm, 2 x 0.8ohm, or 2 x 1ohm).