Vaporesso Luxe Q Cartridge (x2)

To use your Luxe Q and Luxe QS podmods, you will need the Luxe Q cartridges, made by the same manufacturer.

These disposable 2ml cartridges are sold in a pack of 4, with a 0.6Ω, 0.8Ω, or 1.2Ω coil.

Please note that these cartridges are not compatible with older Luxe Q podmods that do not have a magnetic battery. Be sure to check the compatibility of your equipment. 

Vaporesso’s Luxe Q cartridge

Four disposable cartridges for the Luxe Q and Luxe QS

The Luxe Q cartridges must be fitted onto the magnetic connector of the Luxe Q or Luxe QS podmods. As they are already fitted with coils, you just have to fill them up with e-liquid and start vaping!

You can choose between two types of cartridges, depending on the draw you want :

• Four 2ml Luxe Q cartridges, each with a 0.6ohm coil, for a fairly tight MTL draw
• Four 2ml Luxe Q cartridges, each with a 0.8ohm coil, for a slightly tighter MTL draw
• Four 2ml Luxe Q cartridges, each with a 1.2ohm coil, for a much tighter MTL draw, better suited to e-liquids with a high nicotine content, nicotine salts or CBD.

Installing the Luxe Q cartridge onto the magnetised connector of Vaporesso’s Luxe QS pod

A sealed coil

The Luxe Q cartridges are disposable because they don’t allow you to change your coil!

Indeed, inside the tank is a sealed coil.

Once the coil has worn out, which occurs every two to three weeks, the entire cartridge must be replaced.

Rotate the cartridge to adjust the draw

The Luxe Q cartridges are designed so that you can adjust your draw in a flash.

Each side of the cartridge has a specific air intake system. By rotating the cartridge 180° and putting it back onto the podmod, you can switch from one airflow to another.

You can choose between a fairly tight draw (restrictive MTL) and an airier one (loose MTL).

Top fill

You may not be used to seeing top-fill systems on pods, as they aren’t that common. But this cartridge has one, which makes the whole process that much simpler!

In order to fill the Luxe Q cartridges with 2ml of e-liquid, you must :

1. Remove the mouthpiece (called ‘drip tip’) from the cartridge
2. Insert the tip of your bottle of e-liquid into the red silicone hole
3. Fill the tank, but not to the brim!
4. Wait 5 to 10 minutes for the coil to prime itself properly
5. Then, and only then, can you vape!

Filling Vaporesso’s Luxe Q cartridges

The Luxe Q cartridges for the Luxe Q and Luxe QS podmods are manufactured by Vaporesso. They are sold in packs of 4, with three coil values to choose from.