Lost Vape Ursa Cartridge (x3)

Discover a pack of 3 cartridges exclusively made for your Ursa Pocket, Nano/Nano Pro/Nano Air, and Ursa Baby/Baby Pro pods by Lost Vape.

Identical to the original cartridge included in the kit of Ursa pod, it will help you to continue to vape. Besides, you can choose between a version in 1.4ohm, 1.2ohm, 1.0ohm, 0.8ohm, or 0.6ohm!

3 cartridges with built-in coils

Extremely sturdy, these coils in PCTG are the hallmark of the Ursa pod. With the pack of 3 cartridges, you can keep enjoying the incredible vape experience that offers this nice small pod especially made for beginners!

One of the biggest advantages, it is really easy to use thanks to the magnetic connector. To change cartridges or to fill them, it is simple to clip or unclip them!

Because it is built in one piece, you don't need to change the coil. When the latter is too old, you need to change it with another one.

The cartridge for the Ursa Nano pod by Lost Vape, in its 0.8ohm version

Cartridges with coils at the value of your choice

To adapt it to all your desires, Lost Vape offers you three types of coils :

1. An Ursa Cartridge with a 1.2ohm coil, for a very tight vape in indirect inhaling (MTL), to use between 6 and 9W
2. An Ursa Cartridge with a 1.0ohm coil, for a tight vape in indirect inhaling (MTL), to use between 8 and 12W
3. An Ursa V2 Cartridge with a 0.8ohm coil, for a slightly more airy vape, to use between 12 and 20W
4. An Ursa V2 Cartridge with a 0.6ohm coil, for a rather airy draw, to use between 14 and 22W

One of the pros of these coils is that they are suitable for vaping e-liquids with nicotine-salt or CBD levels!

When your coil is too old, you just need to change it. To that end, pull the drip-tip (the part that goes in your mouth) to unclip the new cartridge instead. Then, fill the cartridge with e-liquid and wait for ten seconds so that the coil is primed!

An easy filling

With the delicious flavors that this small pod reveals, there's no doubt that you will want to fill your cartridge again and again! Luckily, with its 2.5ml capacity, it offers you hours of vaping.

To fill it, just unclip the cartridge and open the tank by pulling the strip where it is written: 'open'. Insert the cap in your e-liquid and fill your tank. After closing the strip, you only need to clip the cartridge, and it is done!

The side-fill system of the Ursa cartridges by Lost Vape

The 3 Ursa cartridges for the Ursa Pocket, Nano/Nano Pro/Nano Air, and Ursa Baby/Baby Pro pods are manufactured by Lost Vape.