Innokin Klypse Cartridges (x3)

You cannot use your Klypse podmod without its 2ml disposable cartridges, each fitted with a sealed 0.6Ω, 0.8Ω, or 1.2Ω coil.

Discover this pack of 3 Klypse cartridges, made by Innokin!

A stock of cartridges for your Klypse podmod!

While some kits or pods require coils to be installed inside their tank, the Klypse pod only uses disposable cartridges, which must be attached to the base of its built-in battery.

These disposable cartridges are the 2ml Klypse with 0.6ohm, 0.8ohm, or 1.2ohm coil by Innokin! And here, you can get in a pack of 3.

The Klypse pod mod's connector, compatible with Innokin’s Klypse cartridges

A sealed coil inside the tank

The reason why the Klypse cartridges are disposable is that they are made from a single piece, containing a coil inside the tank. In other words, you can’t replace the coil!

When the coil wears out - which happens every two to three weeks on average - you replace the entire cartridge.

Note that you don't need to adjust the pod mod’s power output, the Klypse e-cigarette sets it automatically!

Inside each of Innokin’s Klypse cartridges is a sealed 0.8ohm coil

A tight MTL draw for beginners!

The Klypse cartridges don’t need to be configured before use! The Klypse pod is designed to deliver a tasty vape with an indirect inhale (Mouth-To-Lung).

The draw is therefore tight and the cartridges are great for e-liquids with high nicotine contents, nicotine salts, or CBD!

The air intake of Innokin’s Klypse pod mod

Quickly fill up on e-liquid!

When MTL vaping, there’s no need for a large tank, as it doesn’t burn through so much e-liquid.

That's why 2ml is more than enough for the Klypse cartridges! They will keep you going for a while and are easy and quick to fill, through the cartridge’s side:

1. Remove the magnetized cap of the Klypse pod mod
2. Remove the cartridge from the magnetized connector
3. Pull the tab on the side of the cartridge
4. Tilt the cartridge slightly and insert the tip of your bottle of e-liquid into the hole
5. Fill with e-liquid, but never to the brim
6. Put the cartridge back onto the Klypse pod mod
7. Wait for 5 to 10 minutes for the coil to soak up enough e-liquid

The lateral filling hole of Innokin’s Klypse pod mod

The Klypse cartridges for the Klypse podmods are made by Innokin. They are only sold in packs of 3 at two values to choose from.