THC x Mike Vapes Blaze Solo RDA Glass Cap

Change the look of your Blaze Solo RDA dripper, thanks to THC and Mike Vapes!

Instead of its stainless steel and aluminum bell and 810 drip tip, choose a Pyrex cap, which has a 25mm diameter!

A Glass Cap for the Blaze Solo RDA dripper

This Glass Cap for Blaze Solo RDA is simply a customization piece for your dripper. It is fitted in place of the original Blaze Solo RDA bell and gives it a new look.

With a diameter of 25mm, it will slightly increase the diameter of your Blaze Solo dripper. The air intake can still be adjusted, though, by turning the dripper’s body.

As for the drip tip, there is no need to equip one! This Pyrex bell is molded in one piece and therefore includes a proprietary and non-removable drip tip.

The Blaze Solo RDA dripper by THC and Mike Vapes, once the Blaze Solo Glass Cap is installed

Installing and maintaining the Blaze Solo Glass Cap 

To fit the Glass Cap onto your Blaze Solo RDA dripper, simply do the following:

1. Remove the bell from your Blaze Solo RDA dripper, as if to access its coil deck
2. Grab your Glass Cap and place it on top of your coil deck
3. Adjust your air intake, then start vaping again!

For proper care of your Glass Cap, follow the same procedure as for your Pyrex tanks. Clean it with clear water, then wipe it with a clean cloth!

The Glass Cap for the Blaze Solo RDA dripper is made by ThunderHead Creations (THC), in collaboration with Mike Vapes.