Vaperz Cloud Asgard RDA Dripper

Do you need a good device for tasting your e-liquids and want a lot of vapour?

The Asgard RDA dripper and its 30mm width is there to fulfil both requirements. Its dual-coil deck is made from a qualitative combination of steel and 24K brass and allows you to quickly set up your coil builds. It will accommodate the most enormous builds, without a hitch!

In addition to its 810 drip tips and its beautiful honeycomb air intakes, the Asgard RDA can be equipped with two types of 510 pins. You can opt for a BF pin if you prefer squonking, or a standard pin if you want to use your usual mods, whether they’re electronic or mechanical.

Vaperz Cloud’s Asgard RDA dripper with the G Class V2 SXmini mod

A chunky but elegant dripper

Vaperz Cloud’s Asgard RDA dripper has a massive diameter of 30mm. This is a far cry from the 25mm its predecessor, the Asgard Mini RDA, had!

The Asgard RDA is short and squat, measuring a mere 33mm high but 30mm wide. It’ll fit onto any mod you have, provided it has a connector of at least 30mm, of course.

The Asgard RDA dripper is made from high quality stainless steel, which gives it its clean and elegant look. You can see its name engraved on the side of its body as well.

Sitting majestically on top of the dripper is an 810 drip tip, designed for maximum taste and vapour. Know that there’s another wider drip tip in the kit.

Vaperz Cloud’s Asgard RDA dripper 

A behemoth designed for dual-coil builds!

When you see how massive the Asgard RDA dripper is, you can imagine it was designed for the fans of dual-coil builds!

This chunky rebuildable dripper is wide enough to accommodate the most complex builds. The posts are very straightforward to use. They are also made of steel and 24K-plated brass, which improves conductivity.

The well is deep enough to accommodate your cotton laces and thus allow for a good e-liquid supply!

The dual-coil deck of Vaperz Cloud’s Asgard RDA dripper 

The traditional honeycomb air intakes

Vaperz Cloud’s products are known for their honeycomb air intakes. There's a reason why they have ‘cloud’ in their name, after all!

The Asgard RDA has a total of 54 separate intakes, spread out on either side of the device.

No need to tell you that you’ll get a lot of vapour with this dripper!

There’s an Ultem chimney inside the dripper as well, which guarantees a flawless airflow to your coils. You’ll get rich and concentrated flavours, even if your e-liquids have a high VG content!

The air intakes of Vaperz Cloud’s Asgard RDA dripper 

A pre-installed 510 BF pin, and an optional 510 standard pin!

Vaperzcloud offers its dripper with a bottom-feeder pin as standard, so you’ll be able to squonk right away if you wish. This 510 BF pin is hollow, which allows the e-liquid to rise from your mod to the dripper well.

However, those who don’t want to squonk will be happy to hear that the Asgard RDA comes with a 510 standard pin as well, compatible with most electronic or mechanical mods.

Contents 

• The Asgard RDA dripper
• An extra 810 drip tip
• A 33mm beauty ring
• A standard 510 pin
• An Allen key
• A set of spare parts
• A user guide

The Asgard RDA dripper is manufactured by Vaperz Cloud.

The contents of Vaperz Cloud’s Asgard RDA dripper kit