BP Mods TMD Coils (x5)

To use your nice Pioneer S clearomizer of BP Mods, you'll need compatible coils: the TMD Coils.

The manufacturer offers it here in a bundle of 5, with the ohm value of your choice: for a tight vape, in MTL or airier, in RDL.

These coils are also compatible with the Light Saber X/Model L/Model S kits as well as with the TMD Boro Tank from the same manufacturer.

Quality coils, special Pioneer S

With your Pioneer S clearomizer, the coils are very important. Besides being the key to its operation (you can't vape without these coils), it enables you to vape in MTL just like in RDL!

To that end, BP Mods offers two types of coils, each time in a bundle of 5 :

• 0.3ohm TMD DL Coil: to use between 30 and 40 watts, ideal for an airy draw with direct inhaling
• 1.05ohm TMD MTL Coil: to use between 10 and 13.5 watts for more tight sensations, for indirect inhalation. These coils are particularly adapted to high dosages of nicotine, nicotine salts, or even CBD. Favour e-liquids with a high rate of propylene glycol, at least with 50% of PG.

When and how to change my TMD coil?

The change of coil is needed every two to three weeks. But it depends on the e-liquid vaped and your use of it.

With the Pioneer S clearomizer, here is how to do it :

1. Unscrew the low part of the clearomizer, with the airflow control ring
2. Take the old coil off, then discard it
3. Unwrap the new one and slightly soak its cotton with a few drops of your e-liquid
4. Place it where the old one was, in the middle of the tank
5. Replace the low part of the clearomizer
6. Fill it up if needed

The TMD Coils for Pioneer S clearomizer, Light Saber X, L, and S kits are made by BP Mods. They are only sold in a pack of 5.