Ijust 2/Melo/Lemo 3 EC Head Coils (x5)

Here are the EC Head coils by Eleaf, compatible with a lot of Eleaf's clearomizers and kits. Your Melo, Lemo, and Ijust kits need these to continue working. These robust and durable coils are available in several values, and you will be able to try different types of vaping, from tight (MTL) to airy (RDL/DTL)!

Choose your ohm value among those offered below and make the most of this pack of 5 coils!

Coils suited to your Melo clearomizers and iJust 2 kit

Eleaf offers all sorts of electronic cigarette clearomizers that are easy to use and sometimes operate with the same coils.

It is the case of the Ijust 2, Lemo 3, and the whole Melo range, which all require EC Head coils, available in several models depending on your vaping power and draw:

• 0.18 ohm ECL, to use between 50 and 80w, which can also be used in temperature control mode for a thick and powerful vape.
• 0.3 ohm, to use between 30 and 80w for a mighty flavor rendering that does not overlook the amount of vapor produced.
• 0.5 ohm, to use between 30 and 100w for a colossal amount of vapor and a very faithful rendering of your e-liquid flavors.
• 0.75 ohm ECML, to be used between 8 and 25w, intended for indirect inhaling (tight draw) similar to that of a traditional cigarette and with a stunning flavor rendering.

Installing and changing your EC Head coil

To install your first coil or replace it as soon as it is worn out, you will need to :

1. Access the coil slot, usually by unscrewing the clearomizer's lower part
2. Soak each new coil with a few drops of e-liquid to prime it
3. Place the coil in the slot, then wait 5-10 minutes for it to soak up the e-liquid

The EC Head coils for the iJust 2, Melo 1, 2, 3, 4, 4S, C, and Lemo 3 are made by Eleaf. They are only sold in packs of 5.