Smok RPM3 Coils (x5)

To use Smok’s Nord 5, RPM100 and RPM85 podmods, and enjoy their RDL and DTL vape, you will need the manufacturer's RPM3 coils.

You’ll find them here in a pack of 5, with two resistance values to choose from!

Mesh and sub-ohm coils for flavour and vapour!

Smoktech’s RPM 3 coils are made from a Mesh structure. They heat up faster and more steadily, and they produce great flavours. They’re designed for a direct (DTL) or restrictive  direct inhale (RDL)! As they’re sub-ohm coils, they’ll produce lots of vapour as well.

There are two types of coils to choose from:

• The 0.15 ohm RPM 3 coils (pack of 5), to be used between 40 and 80 watts
• The 0.23 ohm RPM 3 coils (pack of 5), to be used between 20 and 45 watts

Installing and changing the RPM3 Mesh coil

The RPM3 coils go inside the pods' cartridges. To install one or replace an old one, proceed as follows:

1. Unclip the cartridge from the podmod
2. Turn it over
3. First set-up: unpack a coil and soak its cotton wicks with a few drops of e-liquid. Then, insert it into the middle of the tank, in the dedicated slot
4. Replacement: remove the old coil, grab a new one, soak it and insert it where the old one is

The RPM3 coils for the Nord 5, RPM100 and RPM85 podmods are manufactured by Smok. They are only available in packs of 5.