Innokin Zenith 2ml Clearomizer

The Zenith is a compact clearomizer made by Innokin, here in a 2ml version.

Compatible with the Z Coils, it is specially made for a tight vape in direct inhaling (MTL).

The Zenith clearomizer presents a 24mm diameter and will be connected to all mods with a standard 510 pin.

Innokin's Zenith 2ml clearomizer with Eleaf's T80 mod

The design of Zenith clearomizer

The Zenith 2ml clearomizer measures 46mm in height for a 24mm diameter.

Its straight Pyrex is partially covered by a steel structure.

It has a 510 drip tip, particularly suited to a tight draw in indirect inhaling (MTL).

Innokin's Zenith 2ml clearomizer

The Z Coils

The Zenith clearomizer is delivered matched with two Z Coils.

Select the one that suits you according to your needs:

• Z Plexus Coil in 0.5ohm (pre-installed): to use between 14 and 19 watts
• Z Coil in 1.6ohm: to use between 10 and 14 watts

After two to three weeks of use, your coil will start to show some signs of wear (loss of flavors, light burnt taste).

It will be time to replace it with a new one.

For this:

1. Unscrew the clearomizer's low part
2. Pull on the used coil to take it off
3. Soak a new coil with some e-liquid drops
4. Insert the new coil in its compartment in place of the old one
5. Screw the clearomizer's low part
6. Fill your tank with e-liquid
7. Wait for some minutes before vaping so the coil is correctly primed

Adjustable air intakes

You'll have the possibility to adjust the airflow according to your needs.

This is done using an airflow ring located at the bottom of the Zenith clearomizer.

Rotate this ring to open or close the air intake holes, allowing you to switch between a very tight vape and a slightly more airy draw.

The airflow of Innokin's Zenith 2ml clearomizer

A top filling

When it's time to fill the 2ml tank with e-liquid, there's no need to remove the clearomizer from your box.

The Zenith features a convenient top-fill system.

All you have to do is:

1. Unscrew the top of the clearomizer by a quarter turn
2. Insert the narrow tip of your bottle into the filling hole
3. Pour in your e-liquid
4. Screw the top cap back on

Is your coil brand new? Wait 5 to 10 minutes before vaping so that it can properly soak up the e-liquid.

Filling Innokin's Zenith 2ml clearomizer

Box contents

• 1 2ml Zenith clearomizer
• 1 0.5ohm Plexus Z Coil (pre-installed)
• 1 1.6ohm Z coil
• 1 spare drip tip
• 1 set of spare pieces
• 1 user guide

The Zenith 2ml clearomizer is made by Innokin.

Box contents of Innokin's Zenith 2ml clearomizer