Aspire Vilter S Cartridge (x2)

Discover this beautiful set of 2 cartridges with built-in coils specially designed for the Vilter and Vilter S podmods!

Identical to tanks provided in the Vilter S kit, these cartridges also include two paper filters - everything you need to recapture the original experience of this ingenious little podmod!

Cartridges correctly conceived and easy-to-install

At Aspire, we don't skimp on the means to help you stop smoking! That's why, in addition to being practical and very easy to use, these cartridges are particularly ingenious.

Made from PCTG, they are solid and made to conserve the flavors of your e-liquids in optimal conditions.

Finally, the big plus of these cartridges is that they come with paper and PET filters that give the impression of shooting a real cigarette. Why use filters on an electronic cigarette, when e-liquids are not toxic? Simply to facilitate your smoking cessation by giving your brain the impression that it's smoking!

To install your cartridges, it's not complicated, simply pull the cartridge to disengage its magnetic base from the podmod, discard it, and clip a new cartridge in its place.

N.B: it's necessary to fill the tank for 10 minutes during the first use of the cartridge.

The cartridge of the Vilter S podmod by Aspire

Coils in Khantal, flavor, and ease

The Vilter S podmod has especially been designed to imitate the feelings that's why, with the 1.0ohm fixed coils of these cartridges, you will have a delicious indirect inhalation (MTL) that is closer to that of smoking. Therefore, with the fixed coils included in the cartridges of this podmod, you will have a delicious indirect inhale (MTL) which is the closest to that of the cigarette.

Made in Khantal, this resistant material gives great durability to these coils while revealing the flavors of the liquids in all their splendor. Is your heating element nearing the end of its life?

Don't worry: the coil is inseparable from the cartridge, so you can simply change it. No complicated handling!

A filling up in a minute

With its 2ml capacity, the Vilter S cartridge has a good lifespan. When it's time to refill it, it won't take you more than a minute to do so:

1. Pull the cartridge away from the magnetic base;
2. Turn it over so that the base is up;
3. Pull on the tab;
4. Insert the tip of your bottle and fill it;
5. Close the tab;
6. Put the cartridge back in its place.

Remember to wait for a few minutes to make sure the coil is primed.

The filling of the Vilter S cartridge by Aspire

The Vilter cartridges for Vilter and Vilter S podmods are made by Aspire. They are only sold by a set of 2 and accompanied by two filter drip-tips.