Steam Crave Pumper

Increase your dripper's e-liquid capacity with the 12ml Pumper from Steam Crave.

Compatible with all 30mm rebuildable atomizers featuring a 510 connection, this extension attaches to the bottom of your atomizer to feed it from its 12ml tank.

Screw on your atomizer, press the "pump" button to feed your dripper, and vape without interruption.

Steam Crave's Pumper extension with Steam Crave's Supreme V4 RDTA aromamizer

The squonk principle, without the bottle

The Steam Crave Pumper replicates the mechanical operation of a squonk mod and is compatible with all 30mm rebuildable atomizers thanks to its top and bottom 510 connections.

Made of stainless steel and Pyrex, this 30mm-diameter extension attaches directly to your mod and beneath your atomizer.

The principle is simple: pressing the "pump" button (the part located on the side of the extension) draws e-liquid up from the tank to the BF 510 pin connection, thereby feeding your atomizer and the build inside it.

Each press delivers e-liquid, allowing you to precisely control the flow to your coils and avoid dry hits.

The Pumper is particularly well-suited for the following atomizers designed by Steam Crave:

• Hadron RDSA and RDA
• Plus V4 RDTA aromamizer
• Supreme V4 RDTA

Steam Crave's Pumper extension

A 12ml tank for longer capacity

Rebuildable dripper-style atomizers inherently have a limited e-liquid capacity.

The Pumper extension addresses this limitation with its 12ml Pyrex tank, plus a spare Pyrex tank included in the box.

To refill, simply remove the stainless steel cap on the side of the Pumper, insert the tip of your bottle into the opening, and tilt the unit slightly to fill the tank.

Since the tank is made of clear glass, you can monitor the e-liquid level at all times.

Once filled, a few presses of the "pump" button are all it takes to start the flow.

The built-in anti-backflow mechanism helps prevent unwanted e-liquid backflow and ensures clean, hassle-free daily use.

Filling of Steam Crave's Pumper extension

How to install the Pumper?

Follow these steps to install the Pumper extension on your 30mm rebuildable atomizer:

1. Using pliers, remove the "pump" button from the Pumper (the long part on the side of the extension)
2. Apply a few drops of e-liquid to the seal (only on first use)
3. Reattach the "pump" button
4. Fill the 12ml tank
5. Press the "pump" button several times to draw the e-liquid up to the 510 connection
6. Screw your atomizer onto the top 510 connection and start vaping!

The pump button of Steam Crave's Pumper extension

Box contents

• 1 12ml Pumper extension
• 1 spare 12ml straight Pyrex
• 1 set of spare o-rings
• 1 user guide

The Pumper is made by Steam Crave.

Box contents of Steam Crave's Pumper extension