Smok RPM 4 Mesh Coils (x5)

Do you vape Smok's Nord 6 podmod? Here is the RPM 4 Mesh coils compatible with your kit and its Nord 6 Top-Fill empty cartridge.

Sold in a pack of 5, they have a Mesh technology and an enhanced leakproof system.

During your order, you'll have the choice between a pack in 0.15ohm for a draw in direct inhaling (DL) and 0.6ohm for a semi-airy draw (RDL).

A pack of 5 Mesh coils for Nord 6 podmod

The Mesh technology provides a homogeneous, fast-heating surface for your coil, enabling optimal flavor rendering.

This conception also reduces the risk of cotton overheating, helping extend the lifespan of each coil.

Smok offers these coils in two values so you can choose the coil suited to your draw type:

• 0.15ohm RPM 4 Mesh: to use between 30 and 60W (power recommended: 50W), for a very airy vape in direct inhaling (DL)
• 0.6ohm RPM 4 Mesh: to use between 10 and 30W (power recommended: 28W), for a semi-direct vape with a slightly tighter inhaling (RDL)

How to change your RPM 4 coil?

As soon as you feel a light burnt taste or a loss of flavors, it's a sign that it is time to change your coil.

Here is how to proceed in a few simple steps:

1. Detach the cartridge from the Nord 6 podmod
2. Slightly pull on the used coil to take it out of its compartment
3. Install the new coil with some e-liquid drops before installing it
4. Insert the cartridge in place of the old one
5. Clip the cartridge back on the podmod
6. Fill the tank with e-liquid
7. Wait for some minutes so the coil is correctly primed
8. Vape!

The RPM 4 Mesh coils are made by Smok. They are compatible with the empty Top-Fill Nord 6 cartridges and are exclusively sold in a pack of 5.