MPV Aviator Nano Coils (x3)

If you own one of Master Pro Vape’s (MPV) magnificent Aviator Nano podmods, you’ll need some spare coils at some point. Well, you’re in luck ! Here’s a pack of 3 coils, compatible with your e-cigarette’s 2ml cartridge.

The Aviator Nano coils have a resistance of 1.0ohm and are designed for a fairly tight draw with an indirect inhale (MTL).

Save money with this pack of 3 coils

These coils are specifically designed for your podmod's Aviator Nano cartridge and will allow you to continue using it for as long as you want.

Simply insert a new coil where the old one is and you'll be back to vaping in no time.

These coils have a resistance value of 1.0ohm, which results in a fairly tight draw with a Mouth-To-Lung inhale, similar to the feeling you get with a traditional cigarette. This type of resistance is ideal for e-liquids with a high nicotine content, nicotine salts or CBD.

How to change the coil

After two or three weeks of use, your coil will start to wear out. This can be evidenced by weaker or altered flavours, for example. That means it's time to replace the coil with a new one!

To do so, unpack a new coil, then :

1. Remove the podmod’s cartridge from its magnetised connector
2. Flip the cartridge to access the underside of the tank
3. Pull out the old coil
4. Soak the new coil with a few drops of e-liquid
5. Insert it where the old one was
6. Fill your tank with e-liquid
7. Put the cartridge back onto its magnetised connector
8. Wait 5 to 10 minutes before vaping, so that the new coil can prime itself properly

The Aviator Nano coils are manufactured by MPV (Master Pro Vape). They are only sold in packs of three.