Dotmod DotTank Max Clearomizer

Particularly meant for enthusiasts of airy draw in direct inhaling (DL) or restrictive direct inhaling (RDL), the DotTank Max is specially made to hold Dotmod's DotCoil DotAIO V2 coils.

Its bulb pyrex has a capacity of 5ml e-liquid and benefits from a handy top-filling system.

Its standard 510 pin allows you to connect to all mods with a maximal diameter of 25mm.

Dotmod's DotTank Max clearomizer with Aspire's Revolto mod

A protected bulb Pyrex

With its standard design in stainless steel, the DotTank Max can be associated with any mod with a 510 connector.

Versatile, this clearomizer is meant for a vape in an airy draw in DL (direct inhaling) or RDL (restrictive direct inhaling), but also suits tight vape enthusiasts in MTL (indirect inhaling).

With a base diameter of 25mm, the DotTank Max has a bulb tank of 5ml covered by a vape band and an 810 drip tip.

Dotmod's DotTank Max clearomizer

The DotCoil coils

The DotTank Max is compatible with the entire collection of DotCoil coils.

Dotmod delivers the clearomizer with two coils:

• 1 0.15ohm DotCoil: to use between 60 and 80W
• 1 0.3ohm DotCoil: to use between 25 and 40W

How to change the coil of DotTank Max?

To install your new coil, you only have to:

1. Unscrew the bottom part of the clearomizer
2. Soak a new coil of some e-liquid drops
3. Insert the coil into its compartment
4. Screw back the bottom part
5. Wait for some time so the coil is correctly primed with e-liquid

A top airflow of DotTank Max

Dotmod avoids any leakage of e-liquid by providing a top-airflow system to its DotTank Max.

The air is sent by the top of the tank, and its flow is adjustable thanks to a ring located on the top part of the clearomizer.

Make the latter pivot to free more or less the airflow holes: the more the air intakes are open, the more the draw is airy.

The airflow ring of Dotmod's DotTank Max clearomizer

How to fill the 5ml DotTank Max?

When the time comes to fill it with e-liquid, there is no need to take the DotTank Max off its base.

Take your bottle with a dropper tip, then:

1. Unscrew for a quarter turn the top part of the clearomizer to take it off
2. Insert the tip of your bottle into the filling hole
3. Pour your e-liquid: don't pour e-liquid in the hole of the central chimney
4. Screw the top cap back
5. Vape!

Wait for some minutes before vaping it if you use a new coil.

Top filling of Dotmod's DotTank clearomizer

Box contents

• 1 5ml DotTank Max clearomizer
• 1 Vape Band (pre-installed)
• 1 0.15ohm DotCoil
• 1 0.3ohm DotCoil
• 1 spare bulb Pyrex
• 1 set of spare washers
• 1 user guide

The DotTank Max clearomizer is made by Dotmod.

Box contents of Dotmod's DotTank Max clearomizer