Nevoks Feelin 1000mAh Podmod

Discover this convenient pod and easy to use, perfect for people who are new to the vape world! Made to match the needs of old smokers, its use is very intuitive. With the Pod Feelin, you can use nicotine salts and vape in indirect inhalation, which is vividly recommended for those of you who are starting a smoking withdrawal thanks to vaping.

With a cartridge that can have up to 2ml of e-liquid and a high-capacity 1,000mAh built-in battery, this podmod will follow you everywhere without having to charge it or fill it in e-liquid.

Its design is particularly discreet, which makes it easy to shock in your bag or pocket. Discover this buddy that will always be with you!

A podmod as beautiful as it is discreet

With this nice creation, there's no doubt that Nevoks wanted to help the beginners and the ones that look for something discreet. Very light, it only weighs 42g! Once in your pocket, you'll no longer fill it.

With a height of 99.5mm, a width of 22mm, and a depth of 18mm, it fits in your hand, pocket, and bag. Covered in a soft material, its TPE drip tip makes it very pleasant to use.

Made to be used in MTL or direct restrictive inhaling, it will adapt to your needs!

The Feelin 1,000mAh podmod by Nevoks

Intuitive and easy to use

For your biggest pleasure, Nevoks put an NX chip on the pod that manages most of the functionalities for you, all while leaving room for you to personalize your vape. Indeed, this pod can have access to 3 levels of voltage indicated by 3 LEDs:

1. The lowest level of 3.1V, which can allow vaping at 18W with the 0.6ohm coil, and 10W with the 1ohm coil.
2. The second level of 3.4V, 0.6Ω, and at 11.5W with a coil of 1ohm.
3. The highest level of 3.7V. With a 0.6ohm coil, you can then vape at 22W, and 13W with the 1ohm.

To start the heating of the coil, you can push the fire button or draw on the drip tip, which will start the fire automatically.

Like all electronic cigarettes for beginners, the Feelin pod has several protections against overheating, overloading, etc.

The three LEDs of the Feelin Podmod by Nevoks

A 1,000mAh battery for two days of vaping

To help you vape without struggle, Nevoks has put a 1,000mAh built-in battery in the Feelin podmod that enables two days of use without having to charge it.

When the moment comes to fuel up with energy, you just need to connect it to a USB-C port on top and on the left. The biggest advantage of this charging mode is that there's not long to wait before vaping again: this USB port has a technology of fast recharge that can charge the battery of the Feelin pod in only 50 minutes!

The USB-C port of the Feelin podmod by Nevoks

A convenient and easy-to-use cartridge

Vapers know it: the most convenient of electronic cigarettes are the ones fitted with a cartridge! With a system of magnetic clip, the cartridge enables you to fill your tank or change the coil in no time.

The cartridge of the Feelin podmod by Nevoks

Two coils with a long durability

By discovering the Feelin podmod, you'll also discover the SPL mesh coils, a pleasure of flavors that will open a world of possibilities. If they can be used with standard e-liquids, they are perfectly suited for e-liquids with nicotine salts and can be suited to e-liquids with CBD.

With the Feelin 1,000mAh, you can discover two coils :

• A coil of 1ohm, made for use between 10W and 13W in MTL. This coil can have e-liquids with a nicotine dosage of up to 20mg/ml and will be perfect with e-liquids with a VG rate from 40% to 60%. This coil is made for a tight vape with flavors.
• A coil of 0.6ohm that can be used between 18W and 22W. The e-liquids with a maximum of 10mg/ml of nicotine and a vegetable glycerin rate from 60% to 75% will perfectly suit it. This coil will offer you a restrictive DL, with good flavors and a little bit more vapor.

To change your cartridge, you need to pull the cartridge to demagnetize it, pull the used coil, and replace it with a new one. Fill your tank, wait for some minutes for the coil to be soaked, and you're ready for delicious weeks of vaping!

Adjustable air intakes

Made to free all the flavors of e-liquids, the air intakes of the Feelin can be adjusted thanks to the dial on the side of the podmod. You can then say go from indirect inhalation a restrictive direct inhaling!

Made up of holes on both sides of the podmod, you can have long sessions of vaping with it!

The air intakes of the Feelin podmod by Nevoks

An easy-to-fill cartridge with a 2ml capacity

The Feelin podmod is fitted with a cartridge that has a nice capacity of 2ml and is easy to fill.

To refill your podmod in e-liquid, pull on the cartridge and open the strip on the side. You can insert the tip of your e-liquid bottle and fill the tank. Close, replace the cartridge, and there you go!

Well, not just yet actually! Wait for ten minutes after refilling your tank to make sure your coil is correctly soaked.

The side-fill system of the cartridge of Feelin podmod by Nevoks

Contents of the box

• 1 Feelin 1,000mAh podmod
• 1 0.6Ω SPL Coil
• 1 1Ω SPL Coil
• 1 USB-C Cable
• 1 User manual

The Feelin 1,000mAh podmod is made by Nevoks.

Contents of the box of the Feelin podmod by Nevoks